13 Tips for using PPE welding

Published on 30 October 2023 Leestijd : 3 minutes

13 Tips for using Personal protective equipment

HILCO PPE

Our Personal Protective Equipment (PPE), is worn to provide maximum protection against workplace hazards. It protects against hazards such as burns, sparks, electric shock, spatter and UV radiation. Hilco PPE is designed to provide adequate protection to hands, arms, body and neck. Every single item is made out of top grade cow split leather and sewn with Kevlar thread. PPE is important for welders because there are hazards when welding, cutting, and brazing.

Our protective equipment is designed to ensure you can fully concentrate without distraction or injuries. It will provide you freedom of movement and keeps you comfortable and safe. Our PPE is the perfect choice for all types of welding including: stick, MIG/MAG, TIG, as well as cutting and grinding metal.

See our products

13 Tips for using Hilco PPE

Keep clothing clean and free of oils, greases and combustible contaminants.
Wear long-sleeved shirts with buttoned cuffs and a collar to protect the neck. Dark colours prevent light reflection.
Tape shirt pockets closed to avoid collecting sparks or hot metal or keep them covered with flaps.
Pant legs must not have cuffs and must cover the tops of the boots. Cuffs can collect sparks.
Repair all frayed edges, tears or holes in clothing.
Wear high top boots fully laced to prevent sparks from entering into the boots.
Use fire-resistant boot protectors to prevent sparks from bouncing in the top of the boots.
Remove all ignition sources such as matches and lighters from pockets. Hot welding sparks may fuel these objects / liquids.
Wear leather gloves or protective sleeves of similar material. Leather is a good electrical insulator if kept dry.
Wear leather aprons to protect your chest and lap from sparks when standing or sitting.
Wear layers of clothing. To prevent sweating, avoid overdressing in cold weather. Sweaty clothes cause rapid heat loss.
Wear a fire-resistant skull cap or welding hat under your helmet to protect your head from burns and UV radiation.
Wear a welder’s face shield or helmet to protect your face from radiation and flying particles.

Instructions for use

Fitting and sizing: The size of these products is marked on the product. All sizes comply with the EN ISO 11611:2015 / EN420:2003 + A1:2009 for comfort, fit and dexterity.
Storage and transport: When not in use, store the product in a well-ventilated area away from extremes of temperature. If the product is wet, allow it to dry fully before placing into storage.
Inspection before and after use: If the product becomes damaged it will NOT provide the optimum of protection and must be replaced. Never use a damaged product. If in doubt consult the manufacturer.
Cleaning: All performance levels quoted are for products in new condition and cannot be guaranteed if the product is laundered. Hence it is recommended that these products should not be washed or dry cleaned.